License Suggested Action; Network; Format Of Possible Network Exception Messages; Network Example 1 - HP 3PAR StoreServ 7000 Troubleshooting Manual

license Suggested Action

If desired, request a new or updated license from your Sales Engineer.

network

Displays Ethernet issues for the Administrative, File Services, and Remote Copy over IP (RCIP)
networks that have been logged in the previous 24-hour sampling window. Reports if the storage
system has fewer than two nodes with working admin Ethernet connections.
Check whether the number of collisions is greater than 5% of total packets in previous day's
log.
Check for Ethernet errors and transmit (TX) or receive (RX) errors in previous day's log.

Format of Possible network Exception Messages

Network -- "IP address change has not been completed"
Network "Node<node>:<type>" "Errors detected on network"
Network "Node<node>:<type>" "There is less than one day of network history for this node"
Network -- "No nodes have working admin network connections"
Network -- "Node <node> has no admin network link detected"
Network -- "Nodes <nodelist> have no admin network link detected"
Network -- "checkhealth was unable to determine admin link status

network Example 1

Network -- "IP address change has not been completed"

network Suggested Action 1

The setnet command was issued to change some network parameter, such as the IP address,
but the action has not been completed. Use setnet finish to complete the change, or setnet
abort to cancel. Use shownet to examine the current condition.
cli% shownet
IP Address
192.168.56.209
192.168.56.233

network Example 2

Component ---Identifier---- -----Detailed Description----------
Network Node0:Admin

network Suggested Action 2

Network errors have been detected on the specified node and network interface. Commands such
as shownet and shownet -d are useful for troubleshooting network problems. These commands
display current network counters as checkhealth compares error with the last logging sample.
NOTE: The error counters shown by shownet and shownet -d cannot be cleared except by
rebooting a controller node. Because checkhealth is comparing network counters with a history
log, checkhealth stops reporting the issue if there is no increase in error in the next log entry.
cli% shownet -d
IP Address: 192.168.56.209
Assigned to nodes: 0123
Connected through node 0
Status: Active
Netmask/PrefixLen Nodes
255.255.255.0 0123
255.255.255.0 0123
Errors detected on network
Netmask 255.255.255.0
Active Speed Duplex AutoNeg Status
0 100 Full Yes
0 100 Full Yes
Troubleshooting Storage System Components
Changing
Unverified
51