Controller Node and Internal Component LEDs
NOTE:
Enter the locatenode command to flash the hotplug LED blue.
Figure 17 Location of Controller Node LEDs
Table 8 Description of Controller Node LEDs
Callout
1
2
3
Ethernet LEDs
The controller node has two built-in Ethernet ports. Each built-in Ethernet port has two LEDs.
Figure 18 Location of Ethernet LEDs
Table 9 Description of Ethernet LEDs
Callout
1
22
Understanding LED Indicator Status
LED
Appearance
Status
Green
Hotplug
Blue
Fault
Amber
LED
Appearance
Link Up
Green
Speed
Amber
Indicates
Node status Good
On – No cluster
Quick Flashing – Boot
Slow Flashing – Cluster
Node FRU Indicator
On – OK to remove
Off – Not OK to remove
Flashing – locatenode command has been
issued
Node status Fault
On – Fault
Off – No fault
Flashing – Node in cluster and there is a fault
Indicates
On – 1 GbE Link
On – 100 Mb Link