Operation; Heat Levels; Styling And Drying Hair - Silvercrest SWB 300 A1 Operating Instructions Manual

Operation

Heat levels

0 Appliance is switched off
1 Low heat level: ideal for sensitive or fine hair
2 High heat level: ideal for normal hair

Styling and drying hair

You can use the appliance to style small curls and waves and to dry slightly
damp hair .
1) First, dry the wet hair with a towel or blow-dry it . For best results, use the
appliance when the hair is still slightly damp but no longer wet .
2) Insert the plug into the mains power socket .
3) Select the required heat level with the level switch 4 .
4) If necessary, divide the hair into several sections and isolate a single lock .
5) Place the brush attachment 2 at the end of the lock of hair . In the process,
distribute the hair over the entire length of the brush attachment 2 .
6) Rotate the appliance by the handle 5 to roll the lock onto the brush attach-
ment 2 .
7) To release the hair, slide the curl release button 3 towards the handle 5
and hold it in this position . At the same time, pull the appliance down so that
the brush attachment 2 rolls out of the lock .
Note: If you place the brush attachment 2 at the hairline of a single lock
and do not curl the hair, but only brush it, you can achieve a little more
fullness . Be especially careful with longer hair to ensure that it does not get
caught in the bristles .
CAUTION! If any hair gets caught in the bristles of the brush appliance 2,
remove it carefully, e .g . with your fingers . Make sure that you set the level
switch 4 back to "0" beforehand . Risk of burns!
8) Proceed in this way, one lock at a time, until you are satisfied with the result .
Note: If the appliance does not function as expected, unplug it and allow it
to cool down for a few minutes . The appliance is fitted with an overheating
protector!
9) Switch off the appliance by moving the level switch 4 back to "0" .
10) Then remove the plug from the mains power socket .
■ 6 │ GB │ IE
SWB 300 A1