Product Configuration - Canon CXDI-40G COMPACT Service Manual

2.2 Product Configuration

(1) Product Configuration List
1) CXDI-40G COMPACT
No.
1 CXDI-40G COMPACT Imaging Unit
2 Sensor cable
3 Ready lamp
4 Ready lamp mounting shaft
5 Insulation sheet
6 Cable tie
7 Screw (M3x8mm)
8 Operation manual (For imaging unit)
9 Attached documents for medical
10 Warranty registration
11 Warranty card
Safety Booklet for German (WEEE
12
directive)
13 Installation Report
2) CXDI SYSTEM III
No.
1 Power Box
2 X-ray I/F cable
3 Power supply cable (with AC plug)
4 Cable clamp
5 Screw (M4x6mm)
6 Operation manual (Power box)
LAN cable for connecting Control PC / Power Box and Network switch (Switching HUB) for
connecting the multiple Imaging Units shall be procured at each sales company.
- LAN cable (Over category 5)
Recommended length of the cable is 30m or less.
When Control PC and Power Box are connected directly, Cross type is used, but when they
are connected via Network switch, Straight type is used. However, this is not applied when
Network switch has AUTO-MDI/MDI-X function*.
- Network switch (Switching HUB)
Sales companies adopt Network switch (Switching HUB) after conducting the test and the
operation check for Switching HUB that meets the general standard.
2. Installation
Item Name
Item Name
- 5 -
Qty Remarks
1
1 7m
1
1
16
3
4
-
- (JPN)
- (JPN)
- (US)
- (EU)
- (US/EU)
Qty Remarks
1
1 20m
1 3m (100/120/230V)
1
1
-