Logged Events - GE MDS iNET Series Reference Manual

3.7 Logged Events

(See "View Event Log" on Page 73)
The following events allow the transceiver to continue operation and do not make the
blink. Each is reported through an SNMP trap. The left hand column, "Event Log Entry" is what
will be shown in the Event Log.
Table 3-7. Non-Critical Events—Alphabetical Order
Event Log Entry
AP is Not Approved/No Longer
Approved
Association Attempt
Success/Failed
Association Lost - AP Hop
Parameter Changed
Association Lost - AP's
Ethernet Link Down
Association Lost - AP's
Network Name Changed
Association Lost - Local
Network Name Changed
Association Lost/Established
Auth Demo Mode Expired --
Rebooted Radio/Enabled
Auth Key Entered - Key
Valid/Key Invalid
Auth Failed
Bit Error Rate Below
threshold/Above threshold
Certificate Chain
Verified/Invalid
Compression State Changed
to Disabled/Enabled
Connection Established/Lost
Connection Timer Expired
Current AP Dropped - Forced
102
Severity
MAJOR
MAJOR
MINOR
MAJOR
MINOR
MAJOR
MAJOR
MAJOR
MAJOR
MAJOR
INFORMATIONAL
CRITICAL
MINOR
MAJOR
MINOR
INFORMATIONAL
MDS iNET Series Reference Manual
Description
May occur during the Scanning
process at a remote. Indicates that
the received beacon came from an
AP which is not in the "Approved
AP" list. This may be caused by
some remotes hearing multiple
AP's. This event is expected
behavior.
Self explanatory
Self explanatory
Self explanatory
Self explanatory
Self explanatory
Self explanatory
Self explanatory
Self explanatory
AP or Remote using 802.1X
Device Authentication. Logged
when RADIUS authentication fails.
Self explanatory
Self explanatory
Self explanatory
Remote using 802.1X Device
Authentication. Logged when the
Remote and AP have established a
radio link and the RADIUS
authentication can begin to
establish data link.
Remote Prioritized AP Mode. If the
Remote is associated but not to the
highest priority AP, it disconnects
when the configured Connection
Time expires to find a
higher-priority AP.
Self explanatory
05-2806A01, Rev. L
LED
PWR