Hitachi HIDIC EH-150 Applications Manual page 15

Chapter 3 System configuration
3.1 Structure and Parts name
Name and function
5) DIP switch
No Name
1) Lock button This is used when removing the module from the base unit. After it is
installed to the base unit, the fixation can be reinforced using screws. In
this case, use M4×10-mm screws.
2) Reset switch When module is abnormal, module is to be reset by pushing this switch.
3) Connector for By connecting a positioner, setting and writing of internal data, manual
Positioner operation, automatic operation and teaching operations are available.
4) I/O connector This is connector for pulse output and external control input.
5) DIP switch Setting this switch designates the following operating modes. Even if the
switch setting is changed while the module is energizing, the operating
mode will not be changed. To switch operating modes, turn the power
off, then do the settings correctly.
Switch No
1, 2
3
4
5
6
1) Lock button
2) Reset switch
3)Connector for
Positioner
4) I/O connector
ON
1
ON
ON
OFF
OFF
Not used
Ext. COIN disable
Ext. +O.RUN disable
Ext. –O.RUN disable
Model
Weight
Dimension(mm)
Function
OFF
2
ON CW/CCW Pulse Line Output (negative)
OFF CW/CCW pulse Line Output (positive)
ON CK/Sign Pulse Line Output (negative)
OFF CK/Sign Pulse Line Output (positive)
Not used
External permission
Ext. COIN enable
number 4 is turned off, it is valid.)
Ext. +O.RUN enable External CCW overrun Operation (When switch
number 5 is turned off, it is valid.)
Ext. –O.RUN enable
External CW overrun Operation (When switch
number 6 is turned off, it is valid.)
3-1
Chapter 3 System configuration
EH-POS
Approx. 0.18 kg
95
30
Remarks
Positioner is optional.
Connector for cable:
SUMITOMO 3M product
Solder type:10120-3000VE
Case:10320-52F0-008
Caution
When switch number 5,6 is
turned on, external overrun
signal is disable.
Supplementary explanation
Operation (When switch