Replacing A Water Sensor - Huawei Telecom Power TP48200A-HX09A3 User Manual

TP48200A-HX09A3, TP48200A-HX09A4,
TBC300A-DCA3, TBC300A-DCA5 and
TBC300A-TCA2 Telecom Power
User Manual

4.4.17 Replacing a Water Sensor

Prerequisites


Procedure
Step 1 Connect the ground cable to the ESD wrist strap, and put on the ESD wrist strap and ESD
gloves.
Step 2 Remove the water sensor cable from the UIM, as shown in Figure 4-33.
Figure 4-33 Removing the water sensor cable
Step 3 Cut off the cable tie of the water sensor and remove the water sensor.
Issue 04 (2019-11-15)
You have obtained an ESD wrist strap, a pair of ESD gloves, an ESD box or bag, the
cabinet door key, and a maintenance tool kit.
The new water sensor is intact.
Copyright © Huawei Technologies Co., Ltd.
4 Maintenance
88