Table of Contents
Advertisement
Display panel assembly
WARNING!
cool before touching.
1.
Prepare the computer for disassembly
2.
Remove the front panel
3.
Remove the USB assemblies
4.
Remove the speakers
5.
Remove the top system board bracket
6.
Remove the antennas and transceivers
NOTE:
only to move the bracket aside when removing the display panel assembly.
7.
Disconnect the cable from the touch board (1).
8.
Disconnect the display cable from the system board (2).
9.
Remove the 16 Torx screws (3) that secure the display panel assembly to the main computer bracket.
10.
Lift the bracket off the display panel assembly.
NOTE:
For R-touch models, the display panel assembly includes a resistive touch board that is pre-
programmed to the touch glass and mounted separately to the chassis. Be sure to use the same board this is
supplied with the replacement display. Do not mix and match panels and touch boards.
The P-Cap board is mounted on the display panel rear side.
To replace the display panel assembly, reverse the removal procedures.
To reduce risk of personal injury from hot surfaces, allow the internal system components to
(Front panel on page
(USB port assembly on page
(Speakers on page
You have to remove the antenna transceivers to move the top system board bracket. You need
(Preparation for disassembly on page
31).
44).
47).
(System board on page
52).
(Antennas and transceivers on page
19).
50).
Display panel assembly
57
Advertisement
Table of Contents
