Table of Contents
Advertisement
NOTE:
If you do not press
repeatedly press
F10
NOTE:
If the Computer Setup (F10) Utility is set to "fast boot", use one of the following procedures to
access Computer Setup:
●
Before turning on the computer, press and hold F10. Turn on the computer and continue to hold
F10
until the Computer Setup (F10) Utility is displayed.
- or –
●
Follow the Windows 8 instructions for rebooting the computer into the Computer Setup (F10)
Utility.
3.
A choice of five headings appears in the Computer Setup Utilities menu: File, Storage, Security, Power,
and Advanced.
4.
Use the arrow (left and right) keys to select the appropriate heading. Use the arrow (up and down) keys
to select the option you want, then press Enter. To return to the Computer Setup Utilities menu, press
Esc.
5.
To apply and save changes, select File > Save Changes and Exit.
●
If you have made changes that you do not want applied, select Ignore Changes and Exit.
●
To reset to factory settings or previously saved default settings (some models), select Apply
Defaults and Exit. This option will restore the original factory system defaults.
NOTE:
Not all settings shown in the following sections are available for all models
CAUTION:
Do NOT turn the computer power OFF while the BIOS is saving the Computer Setup (F10) changes
because the CMOS could become corrupted. It is safe to turn off the computer only after exiting the F10
Setup screen.
F10
at the appropriate time, you must restart the computer and again
when the monitor light turns green to access the utility.
Computer Setup (F10) Utilities
61
Advertisement
Table of Contents
