Table of Contents
Advertisement
6
Configuring the software
Touch screen calibration
You do not need to install the touch driver software for Microsoft Windows 7 Professional or Embedded
POSReady 7. Touch drivers are already included in those operating systems for this monitor.
HP recommends that you calibrate the touch screen before using the system to ensure that the touch point
registers on the screen where the stylus or finger touches the screen. If at any time you find that the touch
point is not registering properly, you may need to repeat the calibration process.
Calibration for Windows 7 Professional and Embedded POSReady 7
To calibrate the touch module in Windows 7 Professional and Embedded POSReady 7:
1.
In the HP factory image, select Start > All Programs > Load Windows Calibration Tool, then proceed to
step 2.
OR
Open the Start menu, tap the Control Panel link and type "calibrate" in the Search box. Under Tablet PC
Settings, tap the Calibrate the screen for pen or touch input link. In the Tablet PC Settings dialog box,
tap the Calibrate button, then proceed to step 2.
2.
Follow the on-screen instructions to press the target marks on the touch screen. At the end of the
calibration process, the touch module should be aligned with the video and the touch points will be
accurate.
Calibration for Windows 8.1 Professional and Embedded 8.1 Industry Pro Retail
To calibrate the touch module in Windows 8.1 Professional and Embedded 8.1 Industry Pro Retail:
1.
Launch the Control Panel. You can type "Control Panel" in the Search box to access it.
2.
In the Control Panel type "calibrate" in the Search box. Under Tablet PC Settings, tap the Calibrate the
screen for pen or touch input link. In the Tablet PC Settings dialog box, tap the Calibrate button, then
proceed to step 3.
3.
Follow the on-screen instructions to press the target marks on the touch screen. At the end of the
calibration process, the touch module should be aligned with the video and the touch points will be
accurate.
Configuring the MSR
To configure the MSR, refer to the HP Point of Sale Configuration Guide (available in English only). The guide
is available on the system's hard drive. In Windows 7 Professional or Embedded POSReady 7, select Start >
HP Point of Sale Information to access the guide.
58
Chapter 6 Configuring the software
Advertisement
Table of Contents
