Beko METPOINT CID Operation Manual page 24

METPOINT ® CID
24 | 56
-> Pressure (line pressure in bar)
You can set the pressure to any value between 1 and 10 bar.
-> Distance (distance from leak in m)
The minimum and maximum distances depend on the sensor type used.
If the horn is used with laser distance measurements, the measured
distance can be applied directly – to do this, please enable the "Distance
by Laser" option.
Note: In addition, the laser needs to be enabled in order to use the "laser
distance measurement"; see section 9.4
If the laser is disabled, the "Laser?" icon will flash yellow and red.
Original installation and operation manual