Table of Contents
Advertisement
Original installation and operation manual
Note:
In our example, the backlight is set back to 39% after the first touch. After this, the functions can be used "as normal"
again.
Important:
If the Backlight dimming after option is not enabled, the backlight will remain constantly on with the backlight setting
that is currently configured.
12.3.4.2.11 Cleaning
Settings -> Cleaning
In order to reduce energy consumption (while the device is running), you
can enable the "Backlight off after" checkbox to switch off the display
backlight after a defined time interval.
This function can be used to clean the touch panel during ongoing
measurements.
If one minute is not enough to clean the panel, you can simply repeat the
process as necessary.
If you are done cleaning before the minute is done, you can tap and hold
down (one to two seconds) the to abort press long button to cancel.
METPOINT
CID
®
43 | 56
Advertisement
Table of Contents
