Assembly With Gooseneck; Assembly With Parabolic Mirror - Beko METPOINT CID Operation Manual

METPOINT ® CID Original installation and operation manual

8.3 Assembly with gooseneck

Due to its flexibility, the gooseneck tool is used for localized measurements in areas that are difficult to access. it is
connected to the METPOINT ® CID with the included coiled cord.
The camera cannot be used in this case.
To remove the component, disconnect the connection cable. To do this, press the release button on both sides and pull
off the cable.

8.4 Assembly with parabolic mirror

The parabolic mirror is used for measurements at long distances and for strict requirements regarding selectivity and
leak location pinpointing.
It is connected to the METPOINT CID with the included coiled cord.
®
To remove the component, disconnect the connection cable. To do this, press the release button on both sides and pull
off the cable.
Note:
In order to use the parabolic mirror and gooseneck, these components must be enabled on the METPOINT CID during
®
the initial commissioning process in order to save the corresponding component-specific calibration parameters. If this
has not been done at the factory already, the corresponding data will be included on a USB drive. For instructions on
how to enable the components (importing parameters), see section "12.3.2 Export / Import".
Parabolic mirror 2.0 and gooseneck 2.0 will be automatically detected by an intelligent METPOINT CID. In this case,
®
you will not need to import the corresponding parameters.
12 | 56