Panasonic AJ-LT95 Operating Instructions Manual page 43

Setup menus
TIME CODE menu
Item
Superimposed
No.
display
571 TC JUMP
572 V-MON/TC OUT
573 TC PRESET
574 UB PRESET
The underlining indicates the factory setting.
Setting
Superimposed
No.
display
This selects the setting for TC jumping.
0000 OFF 0: No TC jumping.
0001 VTR1 1: TC jumping on the VTR1 side only.
0002 VTR2 2: TC jumping on the VTR2 side only.
0003 ALL 3: TC jumping on both the VTR1 and VTR2 sides.
<Note>
During TC jumping, the tape is cued up to the IN point and then,
using the CTL value of the IN point as a reference, the tape is
prerolled or run up.
When edit recording mode is initiated after the IN point has been
passed through, the unit switches to the TC reference.
This selects whether the video monitor output connector is to be
used as the TC output connector.
When it is to be used as the TC output connector, whether the
phase of the TC signal which is output in the E-E mode is to be
aligned with the video output or input TC is also selected.
0000 V-MON 0: The connector is used as the video monitor output connector.
0001 TCOUT1 1: The connector is used as the TC output connector, and in the
E-E mode the output TC signal phase is aligned with the input
TC signals.
0002 TCOUT2 2: The connector is used as the TC output connector, and in the
E-E mode the output TC signal phase is aligned with the output
video signals.
<Note>
The TCOUT2 can be set only on the VTR2 side.
This selects the time code value of the internal TCG.
00:00:00:00 to 23:59:59:29 (525i mode)
00:00:00:00 to 23:59:59:24 (625i mode)
This selects the user's bit value of the internal TCG.
00:00:00:00 to FF:FF:FF:FF
43
Description of setting
V V
T T
R R
1 2
[
[ [
[ [
[ [