Table of Contents
Advertisement
Troubleshooting
In case of any abnormality during use, please read the Manual carefully
before sending it for repair, and check whether it is caused by the fol-
lowing conditions.
Common faults
The heating pipe does not light
up after the timing knob is ro-
tated.
There are yellow spots or the
product place is burnt.
There is smoke or peculiar
smell.
The food cannot be toasted
thoroughly in the middle.
The outside is burnt during
baking.
There is an error in the timer.
The timer does not run proper-
ly.
During baking, the heating pipe
lamp does not light up or turns
on and off.
Warning
It is very dangerous to repair by non-professional service personnel. If you encounter
any problems during use, please contact our customer service center.
Non-professionals are prohibited from disassembling this product, which may cause danger.
If the power cord is damaged, it must be replaced by the manufacturer, its maintenance de-
Cause
serted into the socket.
Continuous baking leads to
high temperature in the oven.
The debris or dirt adhered to
the residue
The
is not
installed properly.
Empty cooking is not performed Be sure to perform empty
Chips and dirt adhered to
the
are burn-ing.
The baking time is too short.
The middle part of the food is During baking, please try to cut
The baking time is too long.
The timer is of clockwork type,
so an error sometimes occurs.
When it is set to less than 10
minutes, the timer sometimes
does not run normally.
The thermostat is running with
the baking temperature being
adjusted.
EN-13
Solution
-
Please insert the power plug
When the temperature in the
oven rises, the temperature
controller starts to run, which
may cause the heating pipe not
to light up.
Please clean the chip tray.
burns.
Please install the chip tray.
cooking when using it for the
liar smell remains, which will be
eliminated after repeated use.
Please clean the chip tray.
Please extend the baking time.
it open or cut it into small piec-
es.
Please shorten the baking time.
No processing is required.
When it is to set below 10 min-
utes, please turn it over 11 be-
fore turning it back.
No processing is required.
-
Advertisement
Table of Contents
