Table of Contents
Advertisement
5. PARAMETERS
5. PARAMETERS
CAUTION
5.1 Parameter list
Never make a drastic adjustment or change to the parameter values as doing so
will make the operation unstable.
If fixed values are written in the digits of a parameter, do not change these values.
Do not change parameters for manufacturer setting.
Do not set a value other than the described values to each parameter.
POINT
For parameters of servo amplifiers, refer to "MR-J4-_B_(-RJ) Servo Amplifier
Instruction Manual" or "MR-J4-_A_(-RJ) Servo Amplifier Instruction Manual".
POINT
The parameter whose symbol is preceded by * is enabled with the following
conditions:
*: After setting the parameter, cycle the power or reset the controller.
**: After setting the parameter, cycle the power.
Abbreviations of operation modes indicate the followings.
Standard: Standard (semi closed loop system) use of the rotary servo motor
Full.: Fully closed loop system use of the rotary servo motor
Lin.: Linear servo motor use
DD: Direct drive (DD) motor use
5 - 1
Advertisement
Table of Contents
