Fujitsu WSYA050ML3 Design & Technical Manual page 118

• State cooling circuit 1 (8004)
End use (Info level)
Dew point sensor activated
Manual action active
Fault
Frost protection active
Cooling mode locked
Cooling mode restricted
Comfort cooling mode
Cooling protection mode
Frost protection active
OT cooling limitation activated
Off
Cooling mode off
• State heat pump (8006)
End use (Info level)
Emergency mode
Fault
Locked
Limitation time active
Frost protection active
Defrosting activated
Cooling mode active
Heating
Frost protection active
Off
Switch-off delay active
3-18. State functions
Commissioning, Engineer
Dew point sensor activated
Manual action active
Fault
Flow frost protection active
Locked, heating mode
Lock time after heating
Locked, generator
Locked, storage tank
Flow temp setpoint increase by hygrostat
Dew point flow minimum limitation
Outdoor temperature flow minimum limitation
Comfort cooling mode
Switch-off delay active
Cooling protection mode
Frost protection active
OT cooling limitation activated
Off
Room temperature limitation
Flow limitation reached
Cooling mode deactivated
Commissioning, Engineer
Emergency mode
Fault
Locked, outdoor temperature
Locked, external
Locked, economy mode
Consumer flow rate controller
Minimum outdoor temperature use limitation
Maximum outdoor temperature use limitation
Maximum switch off temperature limitation
Maximum OT limitation cooling
Minimum switch off temperature limitation
Compressor minimum switch off time active
Excess heat compensation
Heat pump frost protection
Defrosting activated
Compressor minimum on time active
Compressor 1 on
Compressor minimum on time active
Heat deficiency compensation
Maximum condenser difference limitation
Minimum condenser difference limitation
Compressor 1 and heater on
Compressor 1 on
Heater on
Installation frost protection active
Flow active
Switch-off delay active
No demand
No demand
- (03-60) -
3. Function table