Fujitsu WSYA050ML3 Design & Technical Manual page 73

Line Access
I
1151
This function enables you to set the custom concrete slab drying temperature. This temperature
remains fixed. The concrete slab-drying program stops automatically after running for 25 days.
1156 I
1157 I
S
1200
Operation mode at the end of concrete slab drying period
Adjustment function details:
• Operating mode
For heating circuits, there are several functions available which can be individually adjusted for
each heating circuit. The programming lines for the 2
tension module has been connected to the controller. Operation of heating circuits 1 and 2 is di-
rectly controlled via a operating mode key.
• Setpoint values
HC1
710
712
714
716
– Room temperature:
Room temperature can be set according to different setpoint values. Depending on the selected
mode, these setpoints are activated and provide different temperature levels in the rooms. The
ranges of configurable setpoints are defined by their interdependencies, as shown in the graph
below.
– Frost protection:
The protection mode automatically prevents an excessively sharp drop in room temperature. In
this case, the control adopts the frost protection room setpoint.
3-4. Heating circuit 1 and 2 functions
Function
Floor curing setpoint
manually
(if line 1150 = manual)
Floor curing day current
Floor curing day completed
Operating mode changeover
Line
HC2
1010 Comfort setpoint
1012 Reduced setpoint
1014 Frost protection setpoint
1016 Maximum comfort setpoint
Setting range or display
0...95°C
0...32
0...32
None, Protection mode,
Reduced, Comfort,
Automatic
nd
heating circuit are displayed only if the ex-
Function
Reduced setpoint
Frost prot. setpoint
- (03-15) -
Setting Factory
increment setting
1°C 25°C
0
Reduced
Comfort setpoint
maximum
Comfort setpoint
3. Function table