D-Link DAP-1155 User Manual page 38

DAP-1155 Wireless N 150 Access Point & Router
User Manual
Click the Reboot line if you have already saved the access point's settings.
Click the Save&Reboot line to save new settings and immediately reboot the access point.
Click the Save line to save new settings to the non-volatile memory and continue configuring the
device. Also you can save the device's parameters via the Save button on the System /
Configuration page.
Click the Backup line and follow the dialog box appeared to save the configuration (all settings of
the access point) to your PC. Also you can save the access point's configuration to your PC via the
Backup button on the System / Configuration page.
Click the Factory line to restore the factory default settings. Also you can restore the factory
defaults via the Factory button on the System / Configuration page.
Also you can restore the factory default settings via the hardware WPS/RESET button. The button
is located on the back panel of the access point. Use a small paperclip to activate the button; insert it
into the hole (with the access point turned on), push, and hold for 3 seconds. Then remove the
paperclip. Wait for about 30 seconds. Now you can access the web-based interface of the access
point using the default IP address, username and password.
When you have configured all needed settings, click the Logout line.
Figure 27. The top-page menu.
Page 38 of 215
Installation and Connection