Dell PowerVault 124T LTO-3 User Manual page 44

15 Timer Error
16 Tick Error
17 Activate Error
18 Threshold Error
19 Suspend Lifted
1A Block Pool Error
1B Queue Function Failed
1C Semaphore Function Failed
1D Timer Function Failed
1F Thread Function Failed
20 Command Started
21 System Failure
22 System Busy
23 System Timeout
24 Software Error
25 Hardware Error
Message Error Types
26 Message Sender (Task ) ID
Error
27 Message Type Bad
28 Message Parameter Bad
Stack/Global Data Corruption Error Types
29 Invalid Element
2A Invalid Element Status
2B Element Table Bad
2C Global Data Bad
2D Stack Data Bad
2E Task Stack Low
2F Task Stack Overflow
System Shutdown/Disruption Error Types
30 POST Failure
31 Watchdog Timer
32 Power Event
33 Power Down Failure
34 System Overload
35 System Performance
36 Asynchronous Stop
System Miscellaneous Error Types
37 System Cleaning Error
38 System Internal I2C HW Error
39 ALD (Autoloader Diagnostic)
Limits Error
Verify the host backup application and device driver are at the latest supported revision at
l
support.dell.com.
Check host adapter and SCSI cables and terminator.
l
Power cycle the autoloader and retry the operation.
l
If all previous steps fail, contact support.dell.com.
l
Verify the host backup application and device driver are at the latest supported revision at
l
support.dell.com.
Power cycle the autoloader.
l
Run the Random Moves test from either the Remote Management Unit (RMU) or the Operator Control
l
Panel (OCP).
Note: The Random Moves test requires a minimum of two cartridges present within the autoloader.
If all previous steps fail, contact support.dell.com.
l
Verify that the magazines/magazine blank are fully seated.
l
Power cycle the autoloader.
l
If all previous steps fail, contact support.dell.com.
l
Power cycle the autoloader.
l
Run the Random Moves test from either the Remote Management Unit (RMU) or the Operator Control
l
Panel (OCP).
Note: The Random Moves test requires a minimum of two cartridges present within the autoloader.
Check support.dell.com for PowerVault 124T firmware updates.
l
If all previous steps fail, contact support.dell.com.
l
Cleaning slot in use.
Verify that a valid cleaning cartridge is located in the dedicated cleaning slot indicated within the
l
Remote Management Unit Configuration page settings.
Check support.dell.com for PowerVault 124T firmware updates.
l
If all previous steps fail, contact support.dell.com.
l
Contact support.dell.com.
This error may occur as a result of a failed diagnostic test.
If the Magazine Test or Inventory Test failed, remove and inspect the magazines
l
one at a time. Turn the white thumbwheels on each magazine and insure that the carriers move
freely at
least one full rotation in each direction. Re-insert each magazine after inspection.
Get other manuals https://www.bkmanuals.com