Table of Contents
Advertisement
38 Electrical installation
If the outer surface of the shield is non-conductive:
•
Cut the shield at the midpoint of the peeled part. Be careful not to cut the
conductors or the grounding wire.
•
Turn the conductive side of the shield inside out over the insulation.
•
Cover the exposed shield and the peeled cable with copper foil to keep the shielding
continuous.
A
B
2
1
C
A
Stripped cable
B
Conductive surface of the shield exposed
C
Stripped part covered with copper foil
1
Cable shield
2
3
2
Copper foil
4
3
Shielded twisted pair
4
Grounding wire
Advertisement
Table of Contents
