Selecting The Speed Setting - Silvercrest 360503 2010 Operating Instructions Manual

Fig. 1
5) Press the measuring cap 1 into the lid as far as the stop.
6) Place the completely filled and closed blender 3 with the handle to the
right on the motor block 6. Make sure that the arrow
points to the
back and forth if it does not immediately sit properly. The motor cannot start
until the blender 3 is fitted flush to the motor unit.

Selecting the speed setting

Once the blender 3 is filled and sitting completely closed on the motor block 6,
you can switch on the appliance.
Set the switch 5 to ...
■ Level 1 – 3
for liquids or soft foodstuffs, for mixing, blending and stirring
■
Level 3 – 5
for more solid foods or for chopping
■
Level P (pulse function)
for short, powerful impulse operation, e.g. for crushing ice cubes or when
cleaning. To prevent overloading the motor, the switch 5 does not lock in this
position. Therefore, hold the switch 5 in this position for short periods only.
NOTE
Fill the blender 3 with a maximum of 250 ml of ice cubes.
►
Otherwise, the ice cubes will not be crushed optimally.
│ GB │ MT
■ 62
Fig. 2
arrow on the motor block 6. Turn the blender 3 slightly
on the blender 3
SSMC 600 B1