Table of Contents
Advertisement
4. Start the device.
To commission the analyzer modules, follow the procedure described in the section
"Commissioning (Page 121)".
5. Enter the user-specific parameters of the basic device again.
If the parameters have been saved on a PC using SIMATIC PDM, download the parameters to
the device.
11.7
Replacing the processing module
Procedure
①
②
③
④
⑤
⑥
Figure 11-3
Wall-mounted device
Operating Instructions, 07/2023, A5E31930403-AB
Power cable
12-pin ribbon cable to the AM (CAN bus)
Processing unit (PU)
26-pin ribbon cable to display
Connecting cable OM 1.1 - PU
Option module OM 1.1
Cabling using OM 1.1 and OM 2.1 as an example
Maintenance and servicing
11.7 Replacing the processing module
⑦
Connecting cable TB - PU
⑧
Connecting cable TB - OM 1.1
⑨
Connecting cable TB - OM 2.1
⑩
Option module OM 2.1
⑪
26-pin ribbon cable to the AM1
⑫
26-pin ribbon cable to AM2
149
Advertisement
Table of Contents
