Table of Contents
Advertisement
Installing / removing and connecting analyzer and option modules
7.11 Installing option modules
Performing installation
①
Option module OM 2.1
②
Screw, printed circuit board holder
③
Printed circuit board holder
④
Screw, electronics base plate
Figure 7-14
Installing option module, example OM 2.1
1. Loosen the screws
2. Loosen the screw
3. Remove the blanking cover plate for option modules.
4. Insert the option module
Fasten the option module with the two screws
5. Insert the printed circuit board holder
Tighten the screw
6. Fit the electronics base plate
panel of the wall-mounted device.
Tighten the screws
84
⑤
Screws for option module (2 units)
⑥
Electronics base plate
⑦
Screw, electronics base plate
⑧
Shielding plate signal lines
④
⑦
and
. Remove the electronics base plate
②
and remove the printed circuit board holder
①
into the electronics base plate
③
②
with a torque of 2.0 Nm.
⑥
with the two screws
④
⑦
and
with a torque of 2.0 Nm.
⑥
at the respective slot.
⑤
with a torque of 1.3 Nm.
again.
④
⑦
and
at the rear panel and side
Operating Instructions, 07/2023, A5E31930403-AB
⑥
.
③
.
Wall-mounted device
Advertisement
Table of Contents
