Figure 2.9 Logging In To The Security Administrator Account - Fujitsu ETERNUS LT140 User Manual

Chapter 2 Setup and Operation Procedures
2.1 Basic Setup
2.1.2.4 Connecting to the Remote Panel after Enabling SSL
The method for connecting to the remote panel after SSL is enabled is provided below.
Procedure
1
Enter "https://(IP address of the tape library)" in the address bar on the web browser.
2
Any attempt to connect to a web service that is not registered as an approved site causes a
security certificate warning to appear.
3
Click [Continue to this website (not recommended)].
The remote panel is connected while SSL is enabled.
"Certificate Error" is displayed in the login screen. This does not cause any problems to the remote panel
operations.
4
Select [security] from the [User] pull-down menu.
5
For [Password], enter the security administrator account password and click [Login].

Figure 2.9 Logging in to the security administrator account

FUJITSU Storage ETERNUS LT140 Tape Library Key Management Function Option User's Guide
29
Copyright 2019 FUJITSU LIMITED
End of procedure
P3AG-3762-02ENZ0