Figure 2.12 Setting The Key Management Function Per Partition - Fujitsu ETERNUS LT140 User Manual

Chapter 2 Setup and Operation Procedures
2.1 Basic Setup
After the default settings of the key management function are changed by using this step, the setting
to enable or disable the key management function is automatically selected based on the default
settings when a new partition is created.
If the default settings are not changed, omit this step and proceed to
3
Apply the default settings of the key management function to all existing partitions.
Click [Apply to all existing partitions]. Confirm that [LT Encryption (Licensed)] is selected for all the par-
titions displayed in [Set Encryption Mode per Partition].
If the default settings are not applied to the existing partitions, omit this step and proceed to
4
Allow the administrator account permission to set the key management function.
Select the checkbox in [General Settings] to allow the administrator account permission to enable or
disable the settings for the key management function in the Expert Partition Wizard.
For details about the Expert Partition Wizard, refer to "3.4.13.2 Using the Expert Partition Wizard" in
"FUJITSU Storage ETERNUS LT140 Tape Library Use's Guide -Panel Operation-".
When the Expert Partition Wizard is used with the security administrator account, the setting for the
key management function can be enabled or disabled at any time.
5
Enable or disable the key management function for each logical library (or partition).
From the pull-down menu of [Set Encryption Mode per Partition] for each partition, select [LT
Encryption (Licensed)] to enable the key management function or [Controlled by Backup Application]
to disable it.

Figure 2.12 Setting the key management function per partition

If the default settings are applied to all partitions in
required.
6
Click [Submit].
FUJITSU Storage ETERNUS LT140 Tape Library Key Management Function Option User's Guide
Step 3
32
Copyright 2019 FUJITSU LIMITED
Step 4.
without any changes, this step is not
P3AG-3762-02ENZ0
Step 4.