Toro 08120 Operator's Manual page 10

5
Installing the Heater Box
Assembly
Parts needed for this procedure:
2 Hex bolt (5/16 x 3/4 inch)
2 Carriage bolt (1/4 x 3/4 inch)
2 Locknut (1/4 inch)
Procedure
Note:
If the machine has the glass windshield and
wiper kit installed, remove the washer bottle from the
frame of the machine. Install it onto the side of the
heater box assembly after the heater box is installed
on the machine (see step 3).
1. Attach the front of the heater box assembly to
the frame of the machine with 2 hex bolts (5/16
x 3/4 inch).
Figure 17
1. Hex bolt (5/16 x 3/4 inch)
2. Machine frame
g399053
3. Heater box assembly
2. Attach the back of the heater box assembly
to the dash brackets on the machine with 2
carriage bolts (1/4 x 3/4 inch) and 2 locknuts
(1/4 inch); refer to
1. Locknuts (1/4 inch)
3. If the machine has the glass windshield and
wiper kit installed, install the washer bottle onto
the side of the heater box assembly as shown
in Figure 19.
10
Figure 18.
Figure 18
2. Carriage bolts (1/4 x 3/4
inch)
Figure 19
g460678
g429465