Table of Contents
Advertisement
3
Cutting the Holes for the
Vents
No Parts Required
Procedure
1.
Locate the 4 drill pilot dimples on the top of the
dashboard
(Figure
or 3 inches) directly over the pilot dimples.
Note:
Use a 76 mm (3 inch) hole saw to drill
the vent holes.
1. Drill pilot dimples
11) and drill 4 holes (76 mm
Figure 11
2.
Locate the 2 drill pilot dimples on the floorboard
(Figure
12) and drill 2 holes (76 mm or 3 inches)
directly over the pilot dimples.
Note:
It is recommended to use a 76 mm (3
inch) hole saw to drill the vent holes.
3.
Remove the burrs from the holes.
1. Drill pilot dimples
g398901
7
Figure 12
g398912
Advertisement
Table of Contents
