Table of Contents
Advertisement
8
Connecting the Battery
No Parts Required
Procedure
Connect the negative (-) battery cable to the battery
post.
Figure 24
1. Negative (-) battery cable
g365493
2. Battery post
9
Burping the Cooling
System
No Parts Required
Procedure
WARNING
If the engine has been running, the
pressurized, hot coolant can escape and
cause burns.
• Do not open the radiator cap when the
engine is running.
• Use a rag when opening the radiator cap,
and open the cap slowly to allow steam to
escape.
Coolant type: 50% ethylene-glycol with organic
additive technology (OAT) 50% distiller water
1.
Remove the cap from the cooling system
reservoir.
2.
Fill the cooling system reservoir until coolant
reaches the lower line within the reservoir.
3.
Rotate the temperature-control knob to full heat.
4.
Start and run the engine until the cooling fan
cycles.
When the machine is at operating temperature,
the coolant level within the reservoir should be
at the upper line.
5.
Add coolant as necessary to replace air that has
been purged from the cooling system.
6.
Install the cooling system reservoir cap.
14
Advertisement
Table of Contents
