Table of Contents
Advertisement
4
Assembling the Heater Box
Assembly
Parts needed for this procedure:
1
Heater box assembly
1
Heater mount bracket
6
Carriage bolt (1/4 x 3/4 inch)
6
Locknut (1/4 inch)
1
Coolant hose (5/8 x 13 inches)
1
Coolant hose (5/8 x 26 inches)
8
Vent hose (2 x 18 inches)
2
Y-adapter
2
Band clamp
16
Cable tie
6
Vent
Procedure
Important:
Do not interfere with the shifter
linkage or steering column when installing the
hoses.
1.
Connect 6 vent hoses to the adjustable vents
using 6 large cable ties
Note:
Ensure that the vents are orientated to
blow air toward the operator on the operator's
side of the machine and toward the passenger
on the passenger's side.
2.
Route the hoses and install the 4 adjustable
vents into the 4 top holes
3.
Route the hoses and install the 2 adjustable
vents into the lower 2 holes
4.
Connect the 2 outer vent hoses to the 2 lower
hoses using the 2 Y-adapters and 4 cable ties
(Figure 13
and
Figure
Connect 2 additional vent hoses to the
assembled outer vent hoses and secure them
using 2 cable ties
5.
Connect the 4 vent hoses to the heater box
using 4 cable ties
(Figure
13).
(Figure
13).
(Figure
13).
14).
(Figure 13
and
Figure
14).
(Figure 13
and
Figure
14).
1. Vent
2. Y-adapters
1. Outer hose assemblies
8
Figure 13
3. Cable tie
Figure 14
g460891
g460561
Advertisement
Table of Contents
