Hitachi airPoint Room700 Operation Manual page 4

1. Safety Summary
•
Do not touch the main circuit board or electronic components in the controller or remote devices.
Make sure that dust and/or steam does not accumulate on the circuit board.
•
Avoid installing the unit in areas where electromagnetic waves are generated, as Electromagnetic interference
(EMI) may cause the equipment to malfunction. Do not install where the waves can directly radiate into the
electrical box, controller cable, or controller. The operation of the unit may also adversely affect these same
devices. Install the unit at least 10 ft. (approximately 3m) away from such devices.
•
If the wired remote controller is installed in a location where electromagnetic energy is generated, make sure
that the wired remote controller is shielded and cables are run inside conduit tubing.
•
If there is a source of electrical interference near the power source, install noise suppression equipment (filter).
•
During the test run, check the unit's operation temperature. If the unit is used in an environment where the
temperature exceeds the operation limits, it may cause severe damage. Check the operation temperature
limits in the manual. If there is no specified temperature, install the unit in a location where the temperture
limits are between 0°C to 40°C.
•
This manual must be read in conjunction with the installation and operation manuals of other equipment
being installed to get a full understanding of the equipoment and installation related topics.
Installation Precautions
WARNING
•
When using the wired remote controller with the built-in temperature sensor, do not install this controller:
○ Where the controller is exposed to direct sunshine.
○ Where the unit is in close proximity to a heat source which will influence the accuracy of temperature
control.
○ Where hot/cold air from the outdoors, or a draft from elsewhere (such as air vents, diffusers, or grilles) can
influence the accuracy of the detection of the actual room temperature.
•
Perform a test run using the controller to ensure normal operation.
After installation work for the system has been completed, explain the "Safety Precautions" use, and maintenance
of the unit to the customer according to the information in all manuals that accompanied the system. All manuals
and warranty information must be given to the end user for safe keeping and future reference.
2
Take the following precautions to reduce the risk of property damage.
Take the following precautions to reduce the risk of electric shock, fire, or
explosion resulting in serious injury or death:
A16381H9HL