Icon Description - Hitachi airPoint Room700 Operation Manual

3. Operation Method

3.7 Icon Description

The status of the remote controller is displayed on the operation screen.
NOTES:
•
It may not be displayed depending on the type of outdoor unit or indoor unit you are using.
•
If there are multiple status, the high priority icon is displayed first.
No.
1
2
3
4
5
6
7
8 A/C
Vent.
THEX Vent.
9
Auto Vent.
Norm. Vent.
10
11
12
o
C
13 **
14 SAG
15 Temporary
16 Setback
17 Purging
18 Setback aborted
19 24-hour ventilation
20 Humidifier is run
21 Motion Sensor ON
22 Radiant Sensor
23 Cold draft restrained
24 Noise reduction
25 FrostWash is complete
IU temp. over range
26
FrostWash stopped
OU temp. over range
27
FrostWash stopped
10
Icon
A schedule timer is set.
The current time has not been set. Schedule timer operation is not possible.
The off timer is set.
The operation lock is set.
Displayed when using the central controller. Control through the wired remote
controller may be restricted depending on the settings of the central controller.
The FrostWash cycle is due to be run. Refer to Page 34 for details on
FrostWash.
It is time to clean the air filter.
Air-conditioning operation is performed.
Ventilation, automatic ventilation, total heat ventilation, and normal ventilation
are operating. These icons appear only when compatible ventilation equipment
is installed.
In Rotation operation. This icon appears only when multiple systems are
installed and the Rotation operation is set.
In backup operation when abnormality occurs.
The standby refrigerant systems operate when abnormality occurs.
This icon appears only when multiple systems are installed and the backup
operation is set.
In backup operation in high load.
If there is a difference between the room temperature and the setting
temperature, the standby refrigerant systems start to operate.
This icon appears only when multiple systems are installed and the backup
operation is set.
Displays the room temperature. (*1)
Elevating grille is not positioned correctly.
Emergency operation is in progress.
When setback operation is enabled and the card key is removed (when no one is
present). (*2)
In night purge progress.
Setback is aborted.
24-hour ventilation is in progress.
The humidifier is in operation.
Indicates capacity savings by motion sensor control during operation or stop.
In order to efficiently heat the room when the radiant temperature is low, the air
flow direction and air volume are automatically controlled.
In order to prevent indoor temperature from being too low.
The operation noise reduction control of the outdoor unit is set.
Indicates the FrostWash cycle has been run and completed.
The FrostWash cycle has been aborted as the indoor temperature is out of the
allowable range 15°C to 30°C.
The FrostWash cycle has been aborted as the outdoor temperature is out of the
allowable range of 1°C to 43°C.
Description
A16381H9HL