Table of Contents
Advertisement
Icon Description
The status of the remote controller is displayed on the home screen.
NOTE
• Some of the status icons below may not be displayed depending on the type of outdoor unit or
indoor unit you are using.
Icon
During the defrosting operation, the defrosting light turns on and the indoor fan stops.
When the defrosting process starts, the run indicator goes out until the defrosting process is finished.
When setback operation is enabled and the card key is removed (when no one is present). (*1)
Displayed when using the central controller. Operation from this wired controller may be limited.
The icon switches as "GentleCool Comfort Level" changes: Low:
The icon switches as "Power Saving Level" changes: Low:
PMEN0630 rev.0 - 07/2022
It is time to clean the air filter.
Then the run indicator comes on again.
The compressor cannot be operated because it is preheating.
An alarm is in progress.
The operation lock is set.
Indicates the service function is performed.
Displays the setting temperature.
Displays the room temperature. (*2)
The operation is stopped.
This is the main remote controller setting.
Use the main remote controller to set the main capacity control setting.
In the case of a single unit, the main does not light up.
In communication with the indoor unit.
The on timer is set.
The off timer is set.
"GentleCool Comfort" mode is ON.
"Power Saving" mode is ON.
"Sleep Mode" is ON.
Description
, Med:
, Med:
, High:
, High:
10
6
Advertisement
Table of Contents
