Table of Contents
Advertisement
NOTE
• Don't use the operation lock function when remote control is set to "prohibit" on the central
controller.
• If both the "prohibit lock" and "prohibit remote control" operations are set at the same time, the
"prohibit remote control" operation has priority.
• If the setting is changed from "prohibit remote control operations" to "permit all remote control
operations", all operation locks are released.
1 Set Operation Lock.
✓ Press " ", " " and " " simultaneously for 3 seconds, the lock icon " " lights up and the
operation lock is in valid.
2 Set Operation Unlock.
✓ Press " ", " " and " " simultaneously for 3 seconds, the lock icon " " lights up and the
operation unlock is in valid.
8.3.2 NFC Setting
The default setting of NFC is "Disabled". When using NFC, the function should be enabled firstly.
Once enabled, there is no need for subsequent enabling process because of its memory function.
Please refer to related manual of airCloud Tap for the operation method of NFC, when available.
NOTE
• NFC is the abbreviation of "Near field communication". NFC can improve service and installation.
• If the wired remote controller may be accessible to unauthorized third-party, please set the NFC
to "Disabled".
◆ Enable NFC function (if NFC is in disabled state)
1 Press " " and " " simultaneously for 3 seconds to display NFC setting screen.
PMEN0630 rev.0 - 07/2022
NFC State
Code
NFC Icon
8
53
Advertisement
Table of Contents
