Table of Contents
Advertisement
Service & Installation Menu
8.1 Test Run
1 Press " " and " " simultaneously for 3 seconds to display the test run screen of Operation
Stop state.
2 Press " " to switch mode and press " " to switch fan speed.
3 Press " " to enter into the test run screen of Operation Start state.
4 Press " " to switch mode and press " " to switch fan speed, and press
test run time.
✓ The setting time range is from 30 minutes to 600 minutes.
✓ Press " " or " " can adjust the test run time by 30 minutes with each single press.
5 Press " " to end the test run and return to home screen.
NOTE
• When a test run request is made from the outdoor unit or central controller, the screen
automatically turns to test run screen.
• After transition to the test run screen, the operation mode and fan speed will remain the same
state before the test run setting.
• In the case of two wired remote controllers, only the primary one can change the test run time.
PMEN0630 rev.0 - 07/2022
Connected Indoor Unit No.
Test Run Time
(120 minutes)
to set the
" " or " "
31
8
Advertisement
Table of Contents
