Table of Contents
Advertisement
Installing ft Remote Management Card
Follow the procedures below and install ft Remote Management Card.
1.
Remove CPU/IO module referring page 8-14.
TIPS:
If PCI board is already installed to the CPU/IO module, remove the PCI board referring to
page 8-38.
2.
Remove PCI rear bracket installed to the CPU/IO
module as a standard with two screws.
3.
Remove the blank cover for LAN connector of ft
Remote Management Card. Grab the top and
bottom of the blank cover to unlock and remove it.
4.
Install ft Remote Management Card to PCI rear
bracket with one screw.
System Upgrade 8-33
PCI rear bracket
Blank cover for
LAN connector
ft Remote
Management
Card
Advertisement
Table of Contents
Troubleshooting
