Hitachi ZW140-6 Operator's Manual page 219

f
NOTE:
1. Further pull lift arm control lever (1) from "Raise"
position (A), the lever is held in the position (F) until the lift
arm moves to the position preset by the lift arm kickout. When
the lift arm moves the preset position, lift arm control lever (1)
automatically moves to the Hold (N) position.
2. Further turn bucket control lever (2) from "Tilt" position
(D) after bucket dump operation, the lever is held in the
position (G) until the bucket moves to the position preset by
the bucket auto leveler. When the bucket moves to the preset
position, bucket control lever (2) automatically moves to the
Hold (N) position.
3. When pushing down lift arm control lever (1) to the
"Float" position (C), the lift arm moves to the position preset
by lift arm auto-leveler system and is held in the position.
When the lift arm moves to the preset position, lift arm control
lever (1) automatically moves to the "Hold" (N) position.
(Machine is equipped with the lift arm auto-leveler system)
f
NOTE: When operating the machine in Float (C) position,
first hold the lift arm at the float position; then further tilt
the lever to the Float position, and lower the lift arm on the
ground.
OPERATING MACHINE
5-3
C
E B
2
N
D A
G F
1
N
MNEC-03-003
M4GB-01-073