Table of Contents
Advertisement
1. Safety Summary
•
Do not touch the main circuit board or electronic components in the controller or remote devices.
Make sure that dust and/or steam does not accumulate on the circuit board.
•
When installing the unit in a hospital or other facility where electromagnetic waves are generated from nearby medical and/or
electronic devices, be prepared for noise and Electromagnetic Interference (EMI). Do not install where the waves can directly
radiate into the electrical box, controller cable, or controller. Inverters, appliances, high-frequency medical equipment, and
radio communications equipment. EMI may cause the unit to malfunction. The operation of the unit may also adversely affect
these same devices. Install the unit at least 10 ft. (approximately 3m) away from such devices.
•
Locate the controller at a distance of at least 3 ft. (approximately 1m) from the electric lighting. Otherwise, the receiver part of
the controller may have difficulty receiving operation commands.
•
If the wired controller is installed in a location where electromagnetic energy is generated, make sure that the wired controller
is shielded and cables are sleeved inside conduit tubing.
•
If there is a source of electrical interference near the power source, install noise suppression equipment (filter).
•
During the test run, check the unit's operation temperature. If the unit is used in an environment where the temperature
exceeds the operation boundary, it may cause severe damage. Check the operation temperature boundary in the manual. If
there is no specified temperature, use the unit within the operation temperature boundary of 32°F to 104°F (0°C to 40°C).
•
Perform properly electrical wiring work. The details of the electrical wiring connection are described in the "Electrical Wiring"
of corresponding Installation and Maintenance Manual.
•
The Eco compact wired remote controller has near field communication (NFC), which can improve service and installation. If
the wired remote controller may be accessible to unauthorized third-party, please set the NFC to "Disable" by referring to the
installation manual.
•
Please read this manual carefully before using the product and keep it properly.
3
Take the following precautions to reduce the risk of property damage.
Advertisement
Table of Contents
