Figure 6-16 Removing A Lithium Battery - Hitachi 65 Instruction Manual

6. CHECKUP AND MAINTENANCE
(2) Removing a lithium battery
[1] Follow the instructions in "6.3.3 Installing and removing the cover of the equipment" to
remove the cover of the equipment.
[2] Remove the lithium battery from the battery holder as shown in the figure below.
[3] Remove the lithium battery from the BAT connector on the motherboard.
(3) Installing a lithium battery
When you install a lithium battery, follow the above procedure in reverse.
< NOTE >
・When you connect a cable, make sure the orientation of the cable is correct
and insert the connector without applying too much force on the connectors.
・In rare cases, when the power is first turned on after the equipment is installed,
the equipment might not power on. In such a case, turn off and on the main
power switch on the back of the equipment, and then try again.
[1]
Battery holder

Figure 6-16 Removing a lithium battery

6-26
[2]