Table of Contents
Advertisement
Tools
#1 Phillips screwdriver
Torx T10 screwdriver
10-18 AWG multipurpose crimping tool
Hardware
AC/DC power cord
Mounting brackets
3 POS power terminal block plug
3 POS power terminal block plug
M4 (#8) ring tongue
Braided or equivalent ground wire
CAT-5 Ethernet cables
#8-32 screws
RUGGEDCOM MX5000
Equipment Manual, 11/2023, C79000-G8976-1059-16
Tools
Tools
1 per power supply For connecting power to a power
1.6 Required tools/hardware
Quantity
1
For removing/installing terminal blocks
and the terminal block cover.
1
For removing/installing modules.
1
For stripping and crimping wires.
Quantity
supply module.
For the required wire gauge, refer
to the power supply specifications
in the
"RUGGEDCOM MX5000
Modules Reference Manual"l [https://
support.industry.siemens.com/cs/ww/
en/ps/21322/man].
4
For mounting the device to a standard
48 cm (19 in) rack.
Two brackets are pre-installed on the
device. An additional two brackets
(including hardware) are also included
for high-vibration or seismically active
locations.
1
For the failsafe alarm relay. The device
includes one screw-type terminal block
plug.
Additional plugs are also available for
purchase. For more information, refer
to "Parts and accessories" (Page 12).
1
For HI AC or DC power connections. The
device includes one screw-type terminal
block plug.
Additional plugs are also available for
purchase. For more information, refer
to "Parts and accessories" (Page 12).
4
For connecting wires to a screw-type
terminal block plug or the chassis
ground connection.
Except for the chassis ground
connection, the ring tongue must have
short insulated ring terminals with a
minimum distance of 5 mm (0.2 in)
from the ring center to the insulation.
1
For grounding the device to safety
Earth.
—
For connecting the device to the
network.
4
For mounting the device to a panel.
Introduction
Detail
Detail
11
Advertisement
Table of Contents
