Speed / Thickness Setting - Mitsubishi Electric LE-50PAU Instruction Manual

4.2 Speed / thickness setting

Similarly to description given on last page, [ 速度 / 厚さ ] key is acceptable from any screen condition on the
screen displayed prior to power failure after turning on the power source.
Ｔ Ｈ Ｋ
速度
厚さ Ｓ Ｐ Ｄ
Ｔ Ｈ Ｋ
▲ ▼
６
設定
クリア
(Example of setting at V=60m/min)
Ｔ Ｈ Ｋ
Ｓ Ｐ Ｄ
セ ッ テ イ
クリア
Ｓ Ｅ Ｔ Ｔ Ｎ Ｇ
< Setting example >
T = 25 µm, V = 60 m/min
速度
厚さ
▼
Ｔ ＝ ＊ ＊ ＊ ＊ ． ＊
ｍ / ｍ ｉ ｎ
Ｖ ＝ ＊ ＊ ＊
Ｔ ＝ ＊ ＊ ＊ ＊ ． ＊
０
実行
Correction
Ｔ ＝ ＊ ＊ ＊ ＊ ． ＊
ｍ / ｍ ｉ ｎ
Ｖ ＝ ６ ０
エ ラ －
Ｅ Ｒ Ｒ Ｏ Ｒ
２ ５ ０
設定
５ ０
設定
実行
μ ｍ
Screen when speed / thickness type ( DPI
•
SW2=ON ) is selected.
μ ｍ
Screen when pulse / thickness type ( DPI
•
SW2=OFF ) is selected.
Select SPD or THK using cursor keys ( , ).
•
This operation is invalid for pulse / thickness
setting method.
Error The left drawing shows an example for case
•
when V = 60 is written with set to SPD.
The following range is valid to V and T respec-
•
Valid
tively.
V = 1 ~ 1,999 m/min
μ ｍ
T = 0.1 ~ 3,276.7 µm
If they are set to out of designated range, the
setting error message is displayed when the [
実行 ] key is pressed, by which no setting is
accepted.
In such a case, press the [ クリア ] key or cor-
rection.
After completion of setting of 25µm, move the
•
実行
" " mark to SPD line.
Afte completion of setting of 60m/min, it is
•
ready to move to the other setting item.
32