Table of Contents
Advertisement
7. Supplementary items
7.1 Special setting operation
It is possible to execute the following special settings by turning on the power source with [MODE] key
pressed.
This special setting mode is reset when the power source is turnin on without the [MODE] key pressed.
1. Special display
MOD
Power ON
MODE
E
Close the power source with
the MODE key pressed.
When the power ampifire mode is selected
(switch #1=on) , "00" is necessarily displayed .
However, when the built - in variable resistor
has been adjusted in accordance with the
procedue shown on page 30, "0 to 99",
"0(100)" is displayed.
Similarly when the built - in variable resistor
has been adjusted in the semi - automatic
contorl mode shown the chapter - 2, "0 to 99",
"0(100)" is displayed.
2. RC input logic
The standard mode is used to validate the PP-PN output when the RC input is turned on.
On the contrary, the standard mode also makes it possible to validate the PP-PN output when the Rc
input is turned off.
Special display
The control output is vaildated
when the RC input is turned on.
Change toe settin from "0" to "1" or from "1" to "0" by pressing the [INC ] key or [DEC ] key, and press
•
the [SET] key.
Special display
When the [MODE] key is presse with the [SET] key
SET
MODE
pressed, the logic inversion setting mode is turned on .
When the same operation is performed again , the
mode is reset and the special display mode is
resumed.
INC
DEC
Power OFF→ON
Close the power source
without the MODE key
pressed.
"1" : RC input logic is inverted .
"2" : Aux. power output timer is set to other
than 10 seconds.
Either "0", "1", "2" or "3" is displayed by the
above two in combination .
"1" : The stop gain is set to other than 100%.
"2" : The stop bias is set to other than 0%.
"4" : The stop timer is set to other than 10
seconds.
Either "0" ~ "7" is displayed by the above
two combination .
The control output is vaildated
when the RC input is turned off.
19
Output display
The last page is displayed.
SET
Correction
SET
MODE
MODE
Advertisement
Table of Contents
