Table of Contents
Advertisement
6. Make sure the planetary gear has grease
on it and locate it back into place and
rotate until gear meshes with the internal
gear.(Fig. 26)
Fig. 26 Locate Planetary
7. Hold the Planetary in place with one
hand and slide the worm follower gear
into place, then the pin for the gear and
then the bevel gear.(Fig.27) You will
then have to replace the snap ring into
place to hold it all in place.(Fig. 28)
Fig. 27 Assemble gears
Fig. 28 Attach Snap Ring
8. Set motor onto Lower Housing and start
the 2 motor screws. Do not tighten
them! Make sure the cord wires are on
the right side of the motor.(Fig. 29)
Fig. 29 Route Cord Wires
st
9. Place 1
stage gear into the location,
Thrust Bearings are farthest away from
the large gear. Notice how the Bearing
flat side face inward. Rotate the gears
back and forth to mesh the gears.
(Fig. 30)
st
Fig. 30 1
Stage Gear
10. Always clean all old grease out before
putting new grease in. *If gears were
damaged make sure you get all grease
cleaned out and there are no debris to
damage new gears.
Advertisement
Table of Contents
