KitchenAid KF26M22 Service Manual page 39

Cosmetic repairs:
Related Mixer Part(s)
Base
Planetary
Upper Housing Cover
Lower Motor Housing
Bowl Support
Column/bowl lift handle
Trim Band
Control Board Knob
Electrical repairs:
Related Mixer Part(s)
Cord
Control Board
Motor
Wiring Harness
Filter(230V)
Hall Effect Sensor
Mechanical repairs:
Appendix B
Troubleshooting Quick Reference Guide
Problem
Bad Paint, Burr,
Bent/Warped, Dented,
Parts Missing
Bent/Warped, Scratched,
Dented, Discolored
Foreign Material on Knob,
Bent/Twisted, Broken
Problem
Mixer doesn't run
Mixer will not turn on.
Motor is overheated or
Over loaded and shuts off
Motor shuts off when
changing speeds
Motor runs up to top speed
and shuts off.
Repair Action
Replace Defective/Missing Part(s)
Replace Trim band
Replace Control Board
Probable Cause(s)
Cord not plugged in
Cord defective
Control not started from
'OFF' position (control
reset)
Control Board Defective
Too Heavy Batter
Motor defective?
Loose connections -check
all connections
open/shorted circuit
Hall Sensor not plugged in
or defective
Magnet on Motor shaft has
fell off or has grease on it.
Repair Action
Plug unit in to power source
Replace Cord
Turn Unit off and wait 10
seconds, turn unit back on.
Replace control board
Shut Mixer off for 15 seconds
and it will reset.
Change Motor
Remove Upper Housing and
check connections
Always HiPot the Unit before
repair begins.
Plug Hall Effect in or replace if
needed
Remove upper housing and
inspect