Table of Contents
Advertisement
LUNA2000-200KTL-H0 Smart Power Control System
User Manual
●
●
General Requirements
Ensure that power is off during installation.
●
●
●
●
●
●
●
●
●
Personal Safety
●
●
●
1.2 Personnel Requirements
●
Issue 05 (2022-06-30)
Damage during transportation by the customer due to failure to comply with
transportation requirements
Storage conditions that do not meet the requirements specified in this
document
D ANGER
Do not install, use, or operate outdoor equipment and cables (including but
not limited to moving equipment, operating equipment and cables, inserting
connectors to or removing connectors from signal ports connected to outdoor
facilities, working at heights, and performing outdoor installation) in harsh
weather conditions such as lightning, rain, snow, and level 6 or stronger wind.
After installing the equipment, remove idle packing materials such as cartons,
foam, plastics, and cable ties from the equipment area.
In the case of a fire, immediately leave the building or the equipment area
and activate the fire alarm or call emergency services. Do not enter the
affected building under any circumstances.
Do not obscure, damage, or block any warning labels on the equipment.
Tighten screws to the specified torque using appropriate tools when installing
the equipment.
Ensure that you are aware of the system's composition and working
principles, as well as any relevant national/local standards.
Repaint any scratched surfaces caused during equipment transportation or
installation in a timely manner. Scratched equipment should not be exposed
to an outdoor environment for extended periods.
Do not open equipment panels.
Do not perform reverse engineering, decompilation, disassembling,
disassembly, adaptation, implantation, or other derivative operations on
device software. Do not study the internal implementation of the device,
obtain the source code of the device software, steal intellectual property
rights, or disclose any of the performance test results of the device software.
If there is a likelihood of personal injury or equipment damage during
operations, immediately stop, report the case to the supervisor, and take
feasible protective measures.
Use tools correctly to prevent personal injury or equipment damage.
Do not touch the equipment while it is in use, as the enclosure is hot.
Installation or maintenance personnel must be well trained, fully understand
all safety precautions, and be able to correctly perform all operations.
Copyright © Huawei Technologies Co., Ltd.
1 Safety Information
2
Advertisement
Table of Contents
