Functions; Led Indications; Information Output Signal Attributes - ABB Tina 10B Product Manual

6

Functions

6.1

LED Indications

LED indication
Green
Green/red flashing
Red
6.2

Information output signal attributes

The information output of the unit is set depending on the state of the safety inputs:
Safety inputs (OSSD1 and OSSD2)
One or both safety inputs OFF
Both safety inputs ON
The delay for switching the information output signal:
Information output signal switch
Delay
Note!
Warning!
2TLC010042M0201 Rev.C
Description
Safety inputs ON (protection OK)
Safety inputs ON (protection OK)
Safety input OFF
Safety inputs at any state
If one or both safety inputs are OFF longer than 70 ms the information
output is set low for approximately 1.2 s. If any of the safety inputs stay OFF
the information output stays low. If any of the safety inputs are OFF for less
than 50 ms the information output will stay high.
Information output signals shall never be used for safety purpose(s).
DYNlink state
DYNlink signal
0 VDC, DYNlink interrupted
before this unit
0 VDC or DYNlink signal
+24 VDC connected to
DYNlink signal input (pin-2)
or interrupted in this unit
Information output
Low
High
High -> Low
~ 160 ms
Low -> High
~ 2 ms
1 1