Komatsu PC220LC -8 Operation & Maintenance Manual page 241

TRANSPORTATION TRANSPORTATION
5. Pass wire ropes between the 1st and 2nd track rollers from the
front and between the 1st and 2nd track rollers from the rear.
However, for machines equipped with a full roller guard for the
track roller, pass the wire rope under the track.
6. Set the lifting angle (A) of the wire rope to 30° to 40°, then lift
the machine slowly.
7. After the machine comes off the ground, check the hook
condition and the lifting posture, and then lift slowly.
Machines With Lifting Hook
In the case of machines equipped with a lifting hook, it is possible to lift the machine as follows.
1. Remove cover (1) on the top surface of the counterweight. The
lifting hook is on the inside of cover (1).
2. Start the engine and set the work equipment to the posture
shown in the diagram on the right. (Boom fully raised, arm,
bucket fully pulled in) set the upper structure facing straight to
the front. (Idler end)
3. Set the lock lever securely to the LOCK position.
4. Stop the engine, check that the area around the operator's cab is safe, then get down from the machine.
Close the cab door, front glass, left and right doors, and engine hood securely.
5. Install shackles to the lifting hooks on top of the boom and counterweight, then fit wire rope.
3 - 186
OPERATION OPERATION