Storage; Troubleshooting - Silvercrest SDBT 2400 A1 Operating Instructions Manual

9) To decalcify the soleplate
large container (e.g. a shallow bowl). You have previously put the remaining
descaling mixture into this container (see step 3).
10) Leave the descaling mixture to soak in for approx. 5 minutes.
11) Remove the steam iron from the container and empty the descaling mixture
into a sink.
12) Put fresh water in the container and dip the soleplate
rinse it off.
13) Remove the steam iron from the container and dry the soleplate
soft cloth.
Note
► After descaling the steam iron, always carry out two rinsing cycles using the
self clean button
tank
suitable.

Storage

Note
► Clean the appliance as described in the section Cleaning the housing
and soleplate before storing it.
Store the cooled down steam iron in a clean, dust-free and dry place away
from direct sunlight.

Troubleshooting

The following table will help you to identify and rectify minor malfunctions.
If the solutions below do not resolve the problem, please contact Customer
Service (see section Service).
Problem
The steam iron does
not get hot.
■ 20 │ GB │ IE
q
w
. Without a subsequent thorough rinsing of the water
e
with tap water or distilled water, the use of a descaling agent is not
Cause
The steam iron is not
connected to a mains
socket.
The automatic switch-
off is activated.
The steam iron is
defective.
, place the steam iron in a shallow, sufficiently
Solution
Plug the power plug into a
mains socket.
Hold the steam iron by the
handle
again.
Contact our Customer Ser-
vice (see section Service).
q
in a few times to
q
with a
7
, so that it heats up
SDBT 2400 A1