Table of Contents
Advertisement
3. SETTING UP THE RAS FEATURE
If this equipment continues to operate while fan failure is detected, internal parts
such as a processor are not cooled down sufficiently, and that may cause thermal
runaway of the system due to malfunction of the equipment or result in damage to
the parts.
If possible, enable the automatic shutdown feature.
NOTE
• If you clear the "Automatically shutdown if fan failure has been detected"
check box, the following cautionary message is displayed. Enable this
function (select the check box) whenever you can.
If you click Cancel when you receive the message above, the check box
reverts back to being selected. If you click OK, the check box is cleared.
• After an automatic shutdown initiated by this function is complete, the power
is turned off.
• The remote shutdown input is polled every 5 seconds. That means it may
take up to 5 seconds from when a remote shutdown is requested to when an
actual shutdown process starts.
NOTICE
3-4
Advertisement
Table of Contents
