Table 5-3 Error Messages Of The Raidctrl Command - Hitachi HF-W6500 60 Manual

5. CONTROLLING THE HARDWARE
<Diagnosis>
When the raidctrl command finishes normally, it returns exit code 0.
If the command returns abnormally, one of the error messages listed in Table 5-3 is
displayed, and the command returns an exit code other than 0.
No. Error message
1 Usage:raidctrl [/OFFLINE DRVNO]
[/NOTIFY [{ON|OFF}]][/LOAD
[{H|M|L}]][/BCC [ON|OFF]]
2 Specified Drive is invalid.
3 No valid drive found.
4 An error occurred in %1. errorcode = %2
5 You do not have the privilege to execute this
command option.
Please execute this command option again on
"Administrator: Command Prompt".
6 Access denied.
Log on console session,
And execute this command option again on
"Administrator: Command Prompt".

Table 5-3 Error Messages of the raidctrl Command

There is an error in the specified options.
Specify correct options.
The drive is not a valid drive status.
No valid drive was found.
An unexpected error (%2) occurred in the function (%1). Retry
the command. If the same error message persists, restart this
equipment.
You do not have administrator privileges.
Log on to the computer using an administrator account and run
the command again. If User Account Control (UAC) is enabled,
start the command prompt with administrator privileges and run
the command.
You cannot use this command with this option from a remote
session.
Log on to a console session and run the command again. If User
Account Control (UAC) is enabled, start the command prompt
with administrator privileges and run the command.
5-10
Description